SERVICE AND ADJUSTMENTS
FRONT WHEEL CAMBER
The front wheel camber is not adjustable on your tractor. If damage has occurred to affect the front wheel camber, contact your nearest authorized service center/department.
B 
FRONT OF TRACTOR
A 
FIG. 30
ADJUSTMENT SLEEVE
TIE ROD
JAM NUTS
ADJUSTMENT SLEEVE
FIG. 31
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig. 32)
•Block up axle securely.
•Remove axle cover, retaining ring and washers to allow wheel removal.
•Repair tire and reassemble.
•Replace washers and snap retaining ring securely in axle groove.
•Replace axle cover.
REAR WHEEL -
•Block rear axle securely.
•Remove five (5) hub bolts to allow wheel removal.
•Repair tire and reassemble. Replace and tighten hub bolts securely.
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.
WASHERS
RETAINING
RING 
AXLE COVER
FIG. 32
TO START ENGINE WITH A WEAK BATTERY (See Fig. 33)
CAUTION:
If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the CUSTOMER RESPON- SIBILITIES section of this manual).
If “jumper cables” are used for emergency starting, follow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
•Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against chassis.
•Connect one end of the BLACK cable to the NEGATIVE
•Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
•BLACK cable first from chassis and then from the fully charged battery.
•RED cable last from both batteries.
“POSITIVE” | (+) | “NEGATIVE” |
|
| L.H. PANEL |
|
| BOLT |
FIG. 33
24
