ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard wrench sizes are listed.
(1) | 1/2" wrench | (1) | Tire pressure gauge |
(2) | 9/16" wrenches | (1) | Utility knife |
(1) Pliers | (1) 3/4" socket w/drive ratchet | ||
When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).
STEERING WHEEL
INSERT
HEX BOLT
LOCKWASHER
FLAT WASHER
STEERING
WHEEL
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
• | Remove all accessible loose parts and parts cartons |
| from carton. |
• | Cut, from top to bottom, along lines on all four corners |
| of carton, and lay panels flat. |
STEERING WHEEL ADAPTER
TABS
STEERING
SHAFT
• | Remove mower and packing materials. |
• | Check for any additional loose parts or cartons and |
| remove. |
BEFORE REMOVING TRACTOR FROM SKID
ATTACH STEERING WHEEL (See Fig. 1)
•Remove hex bolt, lock washer and large flat washer from steering shaft.
•Position front wheels of the tractor so they are pointing straight forward.
•Slide the steering sleeve over the steering shaft.
•Align tabs and press steering sleeve extension into bottom of steering wheel.
•Position steering wheel so cross bars are horizontal (left to right) and slide onto steering wheel adapter.
•Secure steering wheel to steering shaft with hex bolt, lock washer and large flat washer previously removed. Tighten securely.
•Snap steering wheel insert into center of steering wheel.
•Remove protective materials from tractor hood and grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO ROLL OFF SKID.
STEERING
SLEEVE
FIG. 1
HOW TO SET UP YOUR TRACTOR
CHECK BATTERY (See Fig. 2)
•Lift hood to raised position.
•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
LABEL
FIG. 2
6
