Manuals / Brands / Lawn and Garden / Lawn Mower / Husqvarna / Lawn and Garden / Lawn Mower

Husqvarna GTH2250 TO LEVEL MOWER HOUSING, TO REMOVE MOWER (See Fig. 20), TO INSTALL MOWER

1 48

Download 48 pages, 1.89 Mb

20

SERVICE AND ADJUSTMENTS

CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

•Depress clutch/brake pedal fully and set parking brake.

•Place motion control lever in neutral (N) position.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key “OFF” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with

plug.

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or

driveway. Make sure tires are properly inflated (See “PROD-

UCT SPECIFICATIONS” section of this manual). If tires are

over or underinflated, you will not properly adjust your

mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 20 and 21)

•Raise mower to its highest position.

•Measure height from bottom of deck curl to ground level

at front corners of mower. Distance “A” on both sides of

mower should be the same.

•If adjustment is necessary, make adjustment on one

side of mower only.

•To raise one side of mower, tighten lift link adjustment

nut on that side.

•To lower one side of mower, loosen lift link adjustment

nut on that side.

FIG. 21

A

AGROUND LINE

FRONT

SUSPENSION

BRACKET

FRONT

SUSPENSION

BRACKET

RETAINER

SPRINGS

LIFT

LINKS

FIG. 20

RETAINER

SPRING

ADJUSTMENT

NUTS

SUSPENSION

ARMS

CHASSIS

BRACKET

FRONT MOWER

BRACKET

ELECTRIC

CLUTCH

PULLEY

ANTI-SWAY

BAR

RETAINER

SPRINGS

FRONT

LINKS

FRONT MOWER

BRACKET

TO REMOVE MOWER (See Fig. 20)

•Place attachment clutch in “DISENGAGED” position.

•Turn height adjustment knob to lowest setting.

•Lower mower to its lowest position.

•Remove retainer spring holding anti-swaybar to chassis

bracket and disengage anti-swaybar from bracket.

•Remove retainer springs from suspension arms at deck

and disengage arms from deck.

•Raise attachment lift to its highest position.

•Remove two retainer springs from each front link and

remove links.

•Slide mower forward and remove belt from electric

clutch pulley.

•Slide mower out from under right side of tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE

MOWER DECK IS TO BE MOUNTED ON THE TRACTOR,

REMOVE THE FRONT LINKS.

TO INSTALL MOWER

Follow procedure described in “INSTALL MOWER AND

DRIVE BELT” in the Assembly section of this manual.

BOTTOM

EDGE OF

MOWER TO

GROUND

BOTTOM

EDGE OF

MOWER TO

GROUND

TRACTOR

Contents

Main I. GENERAL OPERATION II. SLOPE OPERATION gradual slow SAFETY RULES down Never Do not straight SAFETY RULES WARNING PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES TABLE OF CONTENTS UNASSEMBLED PARTS Steering Wheel (4) Clevis Pins (4) Washers 3/8 x 3/4 x 14 Ga. (2) Front Link Assemblies HOW TO SET UP YOUR TRACTOR CHECK BATTERY (See Fig. 2) TOOLS REQUIRED FOR ASSEMBLY TO REMOVE TRACTOR FROM CARTON UNPACK CARTON INSTALL SEAT (See Fig. 3) TO ROLL TRACTOR OFF SKID (See Operation section, page 11, for location and function of controls) TO ATTACH NOSE ROLLER (See Fig. 4) ASSEMBLE GAUGE WHEELS AND BRACKETS TO MOWER DECK (See Fig. 5) INSTALL MOWER AND DRIVE BELT (See Figs. 6 and 7) CHECK TIRE PRESSURE CHECK MOWER LEVELNESS CHECK FOR PROPER POSITION OF ALL BELTS CHECKLIST WHILE LEARNING HOW TO USE YOUR TRACTOR, PAY EXTRA ATTENTION TO THE FOLLOWING IMPORTANT ITEMS: P KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR. HOW TO USE YOUR TRACTOR TO SET PARKING BRAKE (See Fig. 8) TO USE THROTTLE CONTROL (See Fig. 8) TO USE CHOKE CONTROL (See Fig. 8) TO MOVE FORWARD AND BACKWARD (See Fig. 8) TO OPERATE ON HILLS TO OPERATE MOWER (See Fig. 10) TO TRANSPORT (See Figs. 7 and 11) TOWING CARTS AND OTHER ATTACH- MENTS BEFORE STARTING THE ENGINE CHECK ENGINE OIL LEVEL (See Fig. 12) ADD GASOLINE TO START ENGINE (See Fig. 8) PURGE TRANSMISSION MOWING TIPS T R A C T 0 R MAINTENANCE SCHEDULE SERVICE DATES E N G I N E GENERAL RECOMMENDATIONS BEFORE EACH USE LUBRICATION CHART BRAKE OPERATION TIRES OPERATOR PRESENCE SYSTEM BLADE CARE BLADE REMOVAL (See Fig. 14) V-BELTS CLEAN AIR SCREEN CLEAN AIR INTAKE/COOLING AREAS TRANSAXLE COOLING TRANSAXLE PUMP FLUID CLEANING MUFFLER SPARK PLUGS IN-LINE FUEL FILTER (See Fig. 19) AIR FILTER (See Fig. 18) TO LEVEL MOWER HOUSING TO REMOVE MOWER (See Fig. 20) TO INSTALL MOWER TO REPLACE MOWER DRIVE BELT TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 25) TO ADJUST ATTACHMENT CLUTCH (See Fig. 26) TO ADJUST BRAKE (See Fig. 27) TO REPLACE MOTION DRIVE BELT (See Fig. 28) TO ADJUST MOTION CONTROL LEVER (See Fig. 29) TRANSMISSION REMOVAL/REPLACEMENT TO ADJUST STEERING WHEEL ALIGNMENT FRONT WHEEL TOE-IN ADJUSTMENT FRONT WHEEL CAMBER TO REMOVE WHEEL FOR REPAIRS TO START ENGINE WITH A WEAK BATTERY (See Fig. 33) TO REPLACE HEADLIGHT BULB INTERLOCKS AND RELAYS TO REPLACE FUSE REPLACING BATTERY (See Fig. 34) TO ADJUST ATTACHMENT LIFT SPRING (See Fig. 35) TO ADJUST THROTTLE CONTROL CABLE (See Fig. 37) TO ADJUST CHOKE CONTROL (See Fig. 38) TO ADJUST CARBURETOR STORAGE BATTERY FUEL SYSTEM ENGINE OIL CYLINDER(S) TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION Page SCHEMATIC NON-REMOVABLE CONNECTIONS REMOVABLE CONNECTIONS IGNITION SWITCH RELAY Page ELECTRICAL Page CHASSIS AND ENCLOSURES Page GROUND DRIVE Page STEERING ASSEMBLY SPARK ARRESTER KIT ENGINE SEAT ASSEMBLY WHEELS & TIRES DECALS LIFT ASSEMBLY Page MOWER DECK CUT OUT ON DOTTED LINES THIS IS A 15 SLOPE SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION WARRANTY STATEMENT 531 83 81-23 11/99 CHARLOTTE, NC 28269-3702 7349 STATESVILLE ROAD HUSQVARNA