Husqvarna GX560 manual Assembly with wheels, Fuel

				4
	Assembly (with wheels)
E	1.			Fit the lower handle (E1) to the deck with the lower
				handle pin (E2) as illustrated in Fig E.
	2.			Attach the wheels (F1) to the wheel frame (F2) with the
		1		wheel retaining clips (F3) as illustrated in Fig F.
			3.	Fit the wheel frame (G1) to the deck with the lower
				handle bolt (G2), small washer (G3), large washer
				(G4) and locknut (G5) as illustrated in Fig G.
	4.			Locate the lower telescopic tubes (H1) inside the upper
				telescopic tubes (H2) and secure with the pin (H3) and
				retaining clip (H4) as illustrated in Fig H.

2Fit the Upper Handle to the Lower Handle by following the instructions above in ‘Assembly (without wheels)’

F	1	section.
	3	Handle Position
		The handle position can be adjusted using the guide
		and hook assembly.
	2	1.	Lift hook (C1).
		2.	Position as required:
			(C2)	Parking position
			(C3)	Mowing position

G		H	4
	4		3
5	1		2
	2	1	2
	3		1
			Fuel

J

Use a fresh, clean, unleaded regular automotive gasoline Do not fill the fuel tank in an enclosed area, when the engine is hot or while you are smoking or near a naked flame. Thoroughly clean around the fuel tank filler cap before filling, this will help to prevent dirt being introduced into the fuel system. Fuel should be stored in a cool place away from naked flames. Do not fill the tank while the engine is running. Fill the fuel tank through a funnel fitted with a fine filter. Never fill fuel tank completely, only fill to the base of the filler neck. When filling the fuel tank from empty, or when the engine has previously run dry, a minimum of 400cc of fuel must be added (to the level of the line indicated in diagram J) to ensure correct priming of the fuel pump to start the engine. Your carburettor is pre-set. Normally no further adjustment is required.

Oil

Use 4-stroke automotive detergent oil. SAE 10W-30 is recommended for general use.

Fill with oil as instructed in your Engine Owners Manual provided with your product.