7
Spark Plug
An oily or carboned spark plug makes starting diffi- cult and decreases the efficiency of the engine. Periodically remove the spark plug and clean and adjust when necessary.
Gap setting 0.028 - 0.031".
Do not remove spark plug when engine is hot. Do not sand blast the spark plug to clean it.
Cleaning the Air Filter
Never run the engine without a filter or with a dirty filter. This will greatly reduce engine efficiency and lead to engine damage. Your lawnmower is fitted with an Air Cleaner, the mainte- nance for which is as follows:-
•Check the filter before each use.
•Clean every 25 hrs or more frequently when used in dusty areas.
•Replace filter every 200 hrs.
1.Press the latch tabs on the top of the air cleaner cover and remove the cover.
2.Check the filter is clean and in good condition.
If the filter is dirty:-
Tap the air filter several times on a hard surface to remove dirt, or blow compressed air through the air filter from the clean side that faces the engine. Never try to brush off dirt. Brushing will force dirt into the fibers.
3.Wipe dirt from the air cleaner body and cover using a moist rag. Be careful to prevent dirt from entering the air duct that leads to the carburetor.
4.Replace the filter and air cleaner cover.
S |
|
|
|
|
|
|
|
|
| ||
| Air Cleaner Body |
|
|
|
|
|
|
| |||
| Air Duct |
|
|
|
|
|
|
|
| ||
|
|
| Filter |
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| Air Cleaner |
| |
|
|
|
|
|
|
|
|
| Cover |
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Latch Tabs |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
Caring for your Lawnmower
If you do not intend to use your lawnmower for long periods it is advisable to follow this proce- dure after use:
1.Stop the engine.
2.Fully close the fuel tap. (K)
3.Restart the engine.
4.As fuel runs out the engine will begin to stop, tilt the lawnmower slightly.
5.Once the engine has stopped, release the Operator Presence Control.
6.Disconnect the spark plug lead.
7.Remove all fuel from the fuel tank.
Cleaning - USE GLOVES
•Keep your lawnmower clean - grass clippings left in any of the air intakes, around the engine or under the deck could become a potential fire hazard.
•Do not clean with chemicals, including petrol, or
solvents - some can destroy critical plastic parts.
1.Remove grass from under the deck with a piece of wood or similar.
2.Using a soft brush - remove grass clippings from around the engine and from all air intakes.
3.Remove the fan, See 'Removing and Fitting the Blade and Fan', and clean with a soft brush.
4.Wipe over the surface of your lawnmower with a dry cloth.
Transporting your Lawnmower
•Turn the fuel tap to the off position and transport with the engine in a horizontal position.
•Never transport the lawnmower when it is run- ning.
Storing Your Lawnmower
Turn the fuel tap to the off position and store in a cool, dry,
At the end of the Mowing Season
1.Stop the engine.
2.Fully close the fuel tap. (K)
3.Restart the engine.
4.As fuel runs out the engine will begin to stop, tilt the lawnmower slightly.
5.Once the engine has stopped, release the Operator Presence Control.
6.Disconnect the spark plug lead.
7.Remove all fuel from the fuel tank.
8.Remove the spark plug lead and spark plug. Pour one teaspoon (5ml) of oil through the spark plug hole. Pull the starting handle 2 or 3 times. This will distribute oil on the internal surfaces of the engine. Inspect, clean and replace the spark plug. If a new spark plug is required contact your local approved Electrolux Outdoor Products Service Centre/Dealer.
Do not
9.Clean the air filter. See 'Cleaning the Air Filter'.
10.Renew the blade if it is cracked, damaged or bent. Renew the blade bolt if necessary. See 'Removing and Fitting the Blade and Fan' for complete instructions.
11.Use only genuine Flymo parts and accessories specified for this product.
12.Clean your lawnmower thoroughly See 'Cleaning'.
13.Your local approved Electrolux Outdoor Products Service Centre/Dealer will carry out any service or repairs required.
14.Store your lawnmower in a cool, dry,
