Husqvarna iZ5223TSKAA, iZ4821TSKAA, iZ6123TKAA, iZ4817TSKAA, iZ5223TKOA To adjust anti-scalp rollers

MAINTENANCE

To adjust anti-scalp rollers

Anti-scalp rollers are properly adjusted when they are just slightly off of the ground when the deck is at the desired cutting height in the operating position. Anti-scalp rollers then keep the deck in the proper position to help prevent scalping in most terrain conditions.

IMPORTANT INFORMATION

Adjust Anti-scalp rollers with the mower on a flat level surface.

The anti-scalp rollers can be set in three positions.

•Upper position 1.5” to 3” (38 to 76 mm) grass.

•Middle position 3” to 4.5” (76 to 114 mm) grass.

•Lower position 4.5” to 6” (114 to 152 mm) grass.

The rollers should be approximately 1/4” (6.5 mm) from ground.

IMPORTANT INFORMATION

The anti-scalp rollers must not be used for gauge wheels or the roller and deck may be damaged.

Engine oil cooler

Kohler engine only.

1.Clean the outside of fins with a brush.

2.Remove the two screws holding the cooler unit to the blower housing.

3.Tilt the cooler downward.

4.Clean the inside of the cooler with a brush or with compressed air.

5.Reinstall the oil cooler to the blower housing.

CZ-9

Anti-scalp roller

8011-472

Engine oil cooler

English-49