Invacare X-Terminator Titanium Adjustable Tension Back Upholstery, The Adjustable Tension Straps

SECTION 4—BACK

Adjustable Tension Back Upholstery

WARNING

The position of the footrest, seat angle, back angle, seating system/upholstery, caster size and position, rear wheel size and position, use of anti-tippers, as well as the user condition directly relate to the stability of the wheelchair. Any change to one or any combination of the ten may cause the wheelchair to decrease in stability. EXTREME care MUST be taken when changing the stability of the wheelchair. Refer to the chart in General Guidelines on page 15 of this manual.

NOTE: For this procedure, refer to FIGURE 4.4.

The Adjustable Tension Straps

The straps can be adjusted at various levels of tension to accommodate individual end‐users. The bottom two straps can be adjusted tightly to support and/or assist the extensor muscles.

The Back Upholstery Cover

NOTE: The back upholstery cover is designed for three reasons:

•The first is as a modesty cover.

•The second is to keep the cushion from sliding out of the back of the wheelchair.

•The third is a sacral support depending upon how far or tight the flap is pulled under the seat cushion

Replacing Adjustable Tension Back Upholstery

1.Remove the back height adjustment screws that secure the back canes to the back uprights.

2.Slide the back canes out of the back uprights.

3.Remove the two screws and washers that secure the existing back upholstery to the back canes.

4.Slide the existing back upholstery down and off the back canes.

Back Canes

Back

Upright

Back Height

Adjustment

Screw

Fastening Strap

Back Upholstery Cover

Fastening Straps

Adjuster Strap

Anchor

Loop Back

Cane

	Upper
Back Upholstery	Grommet
	Hole
Anchor Loop Section
Mounting Screw

Back Upholstery Adjuster Strap Section

FIGURE 4.4 Adjustable Tension Back

Upholstery

Everyday and Sport Series Wheelchairs 32 Part No 1114851