Invacare 1114851 manual Replacing/Adjusting Casters, NOTE For this procedure, refer to FIGURE

Models: Terminator BB

1 76
Download 76 pages 7.71 Kb
Page 54
Image 54
Replacing/Adjusting Casters

SECTION 5—WHEELS

Replacing/Adjusting Casters

CAUTION

Changing the size/type of and/or repositioning the front casters can affect the per- formance of the wheelchair. Contact Invacare at the telephone numbers on the back of this manual before performing this procedure.

NOTE: For this procedure, refer to FIGURE 5.18.

NOTE: Non‐suspension casters cannot be adjusted as they mount in one position only.

1.Perform one of the following:

Non‐Suspension Fork ‐ Remove the bolt and locknut that secure the front caster to the fork.

Suspension Fork ‐ Perform the following steps:

i.Using two allen wrenches, turn in opposite directions and remove one mounting screw from the fork.

ii.Remove the mounting screw/threaded sleeve assembly that secures the front caster and two spacers to the fork.

2.Remove front caster and axle spacers from fork.

3.Perform one of the following:

Non‐Suspension Fork ‐ Install the new caster, bolt, locknut and axle spacers onto the fork and securely tighten.

Suspension Fork ‐ Perform the following steps:

i.Determine the desired mounting hole for the caster installation.

ii.Line up the front caster and two spacers with the mounting hole in the fork determined in STEP B‐i.

iii.Reinstall the mounting screw/threaded sleeve assembly through the fork, front caster and two spacers. Refer to FIGURE 5.18 for hardware orientation.

iv.Reinstall the mounting screw into the threaded sleeve and tighten securely.

WARNING

Both front casters MUST be positioned to the same corresponding mounting hole, otherwise injury or damage may occur.

4. Repeat STEPS 1‐3 for the opposite caster if necessary.

NOTE: If replacing front casters with a different size than what was originally on the wheelchair, the front caster height MUST be adjusted to keep the wheelchair frame parallel to the floor. Refer to Adjusting Front Caster Height on page 55. The size of the rear wheels may also need adjustment. Refer to Repairing/Replacing Rear Wheel, Tire/Tube on page 38.

Everyday and Sport Series Wheelchairs

54

Part No 1114851

Page 54
Image 54
Invacare 1114851, X-Terminator Titanium manual Replacing/Adjusting Casters, NOTE For this procedure, refer to FIGURE