Invacare 1114851, X-Terminator Titanium, X-Terminator QR Adjust back canes to back angle required

SECTION 4—BACK

1.Loosen, but DO NOT remove the locknuts and hex screws that secure the back angle bracket to the seat rail and the back cane.

2.Loosen the top locknut and slide the top hex screw away from the back angle bracket to adjust the cam.

3.Adjust back canes to back angle required.

4.Adjust cam to achieve desired position.

NOTE: An indexing notch has been put on the cam to help determine cam position for desired back angle adjustment.

5.Secure cam in desired position. Torque all hex screws and locknuts to 960‐1020 inch pounds (80‐85 foot‐pounds).

NOTE: As shown in FIGURE 4.2, the adjustment cam can be rotated to several different positions thus changing the overall back angle relative to the seat rail.

95° Back Angle to Seat Rail					90° Back Angle to Seat Rail
Back Cane		Indexing			Back Cane
					Indexing Notch
		Notch
TOP Hex
Screw and					TOP Hex
Locknut
					Screw and
						Cam
			Cam		Locknut
Back Angle					Back Angle Bracket
Bracket
		Seat Rail			Seat Rail
85° Back Angle to Seat Rail					80° Back Angle to Seat Rail
Back					Back Cane
Cane	Indexing Notch				Indexing
					Notch
					TOP Hex
					Screw and
TOP Hex Screw					Locknut
and Locknut				Cam		Cam
Back Angle Bracket					Back Angle Bracket
		Seat Rail			Seat Rail

75° Back Angle to Seat Rail

Back Cane	Indexing
	Notch

TOP Hex Screw	Cam
and Locknut
Back Angle Bracket	Seat Rail

FIGURE 4.2 Back Angle Adjustment

Everyday and Sport Series Wheelchairs 30 Part No 1114851