Invacare X-Terminator QR, X-Terminator Titanium manual Back Height Adjustment Adjustable Backs Only

SECTION 4—BACK

5.Stand behind the wheelchair and perform the following:

A.Slide anchor loop section of adjustable tension back upholstery up onto the left back cane with the upper grommet hole facing the rear of the wheelchair.

B.Slide adjuster strap section of adjustable tension back upholstery up onto the right back cane with the upper grommet hole facing the rear of the wheelchair.

6.Align the mounting hole in each back cane with the desired mounting hole in each back upright.

NOTE: Both back canes should be adjusted to the same height.

7.Install the two back height adjustment screws through the back upright mounting holes determined in STEP 6 and the back cane mounting holes.

8.Slip adjuster straps through corresponding anchor loops and adjust the back upholstery. Secure with the fastening straps.

WARNING

After the adjustable tension back upholstery has been positioned to the end-users individual needs, the fastening straps MUST be securely fastened BEFORE applying the back upholstery cover. The adjustable back should be checked whenever enter- ing the wheelchair to ensure that the fastening straps are securely fastened.

9.Secure the back upholstery cover (fastening strap) to the back of the adjustable back upholstery (fastening strap).

10.Flip the back upholstery cover over the adjustable back upholstery and secure the fastening straps to the front of the adjustable back upholstery.

11.Lay the front portion of the back upholstery cover on the seat pan.

12.Adjust the slack in the back upholstery cover and then secure to the seat pan fastening straps.

Back Height Adjustment (Adjustable Backs Only)

NOTE: For this procedure, refer to FIGURE 4.5

NOTE: Observe the tautness of the back upholstery for reinstallation.

1.Unlatch the two fastening flaps that secure the top of the back upholstery to the back canes and remove from the back canes.

WARNING

Push pin MUST be protruding through hole in back cane.

Ensure that both back cane inserts are at the same height BEFORE reassembling the wheelchair.

2.Press the push pin on the back cane insert tube in and adjust the back height to one of four heights depending on original back height:

Part No 1114851 33 Everyday and Sport Series Wheelchairs