6.Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cooling fan blades (F).
7.Remove belt downward from engine pulley and around electric clutch (G).
8.Slide belt toward rear of tractor, off the steering plate (H) and remove from tractor.
BELT INSTALLATION -
1.Install new belt from tractor rear to front, over the steering plate (H) and above clutch brake pedal shaft (J).
2.Pull belt toward front of tractor and roll belt around electric clutch and onto engine pulley (G).
3.Pull belt toward rear of tractor. Care- fully work belt down around transmis- sion cooling fan and onto the input pulley (F). Be sure belt is inside the belt keeper.
4.Install belt on centerspan idler (E).
5.Install belt through stationary idler (C) and clutching idler (D).
6.Reinstall
7.Reconnect clutch harness (A).
8.Make sure belt is in all pulley grooves and inside all belt guides and keepers.
9.Install mower (See “TO INSTALL MOWER” in this section of manual).
G
H
B
A
C 
J
D 
E 
F 
02953 electric
TO CHECK BRAKE
If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.
You may also check brake by:
1.Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.
2.Disengage transmission by placing freewheel control in “transmission dis- engaged” position. Pull freewheel con-
trol out and into the slot and release so it is held in the disengaged position.
The rear wheels must lock and skid when you try to manually push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualified service center.
TO REMOVE WHEEL FOR REPAIRS
1.Block up axle securely.
2.Remove axle cover, retaining ring and washers to allow wheel removal (rear wheels have a square key - Do not lose).
3.Repair tire and reassemble.
NOTE: On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.
4.Replace washers and snap retaining ring securely in axle groove.
5.Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, purchase and use tire sealant. Tire sealant also prevents tire dry rot and corrosion.
Washers
Retaining
Ring
Axle Cover
Square Key (Rear
Wheel Only)
24
