UNASSEMBLED PARTS
Slope Sheet
Keys | (1) Oil Drain Tube |
| |
| For Future Use |
(2) Keys
ASSEMBLY/PRE-OPERATION
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.
When right or left hand is mentioned in this manual, it means, from your point of view, when you are in the operating posi- tion (seated behind the steering wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
1.Cut along dashed lines on all four pan- els of carton. Remove end panels and lay side panels flat.
2.Remove protective materials from trac-
tor hood and grille.
IMPORTANT: Check for and remove any staples in skid that may puncture tires where tractor is to roll off skid.
CHECK BATTERY
1. Lift hood to raised position.
NOTE: If this battery is put into service after month and year indicated on label
(L)(label is located between terminals) charge battery for minimum of one hour at
L |
02931
ADJUST SEAT
1.Sit in seat.
2.Lift up adjustment lever (A) and slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.
3.Release lever to lock seat in position.
A
NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.
WARNING: Before starting, read, un- derstand and follow all instructions in the Operation section of this manual. Be sure tractor is in a
TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)
1.Raise attachment lift lever to its highest position.
2.Release parking brake by depressing brake pedal.
3.Place freewheel control in disengaged position to disengage transmission (See “TO TRANSPORT” in the Op- eration section of this manual).
4.Roll tractor forward off skid.
6
