English – 35
MAINTENANCE
5. Fit the protective cover over the belts and
replace the parallelism arm.
Belt change on cutting unit with side ejection
and Combi 112
On these cutting units with “collision-proof” blades,
the blades are driven by one V-belt. Do as follows to
change the V-belt:
1. Remove the cutting unit.
2. Undo the bolt on the lift strut and the two screws
on the cover. Lift the cover off the cutting unit.
3. Loosen the spring (4) that tensions the V-belt
and pry off the belt.
Simply reverse the procedure to fit the new belt.
8009-287
8009-376
6016-111
IMPORTANT INFORMATION
The blades on a Combi 103 unit should be
set at 90 degrees to each other. In all other
cases the blades can collide and cause
serious damage to the cutting unit.