KEY to Symbols | Husqvarna Rider 213 C, 216 Awd specs

KEY TO SYMBOLS

Symbols

These symbols are on the machine and in the instructions.

WARNING! Careless or incorrect use can result in serious or fatal injury to the operator or others.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

•Approved hearing protection

This product is in accordance with applicable EC directives.

Neutral

Fast

Slow

Stop the engine.

Battery

Choke.

Fuel

Oil level

Cutting height

Backwards

Forwards

Ignition

Hydrostatic freewheel

Warning: rotating parts. Keep hands and feet clear.

Parking brake

Brake

Noise emission to the environment according to the European Community’s Directive. The machine’s emission is speciﬁed in the Technical data chapter and on the label.

Rotary blades Keep hands and feet away from under the hood when the engine is running

Never drive across a slope

Never use the machine if persons, especially children, or animals, are in the vicinity

Never carry passengers on the machine or equipment

Drive very slowly if no cutting unit is ﬁtted

Cutting deck must be ﬁtted before driving at full speed.

English – 3

Image 3

Husqvarna Rider 213 C, 216 Awd manual KEY to Symbols

Contents

English Rider 213 C Rider 216 Rider 216 AWD Contents Symbols KEY to Symbols KEY to Symbols Introduction Service journal Pre-delivery serviceAfter the ﬁrst 8 hours Location of the controls What is WHAT? General use Safety InstructionsSafety instructions Insure your Rider This is what you do Driving on slopes Children Maintenance Transport Lifting lever for the cutting unit PresentationPresentation Cutting unit Release lever Rider 213 C, Rider Cutting height adjustment leverSeat Fueling Driving Before startingStart the engine Remove the cables in the reverse order Starting the engine with a weak batteryConnecting the jump leads Driving the Rider Cutting tips Stop the engineOther objects which can be thrown out by the blades Interval in hours MaintenanceMaintenance schedule Maintenance Daily maintenance At least once Before starting Cleaning Checking and adjusting the steering wiresRemoving of the machine hoods Result in reduced braking ability Adjusting the parking brake Rider 213 C, RiderAdjusting the parking brake Rider 216 AWD Adjusting the throttle wire Replacement of fuel ﬁlter Replacing the air ﬁlterChecking the fuel pump’s air ﬁlter Fuses Check the safety systemChecking the tyre pressure Ignition system Adjusting the parallelism of the cutting unit When the engine is running. Mind your ﬁngersChecking the cutting unit’s parallelism Placing in the service position Service position for the cutting unit Removing the BioClip plug Checking the bladesCombi Changing the oil ﬁlter LubricationChecking the engine’s oil level Replacing the engine oil Rider 216 AWD Lubricating the belt adjusterChecking the transmission oil level General lubrication Troubleshooting schedule Guard ServiceStorage Winter storage Technical Data Cutting unit Combi EC-declaration of conformity Applies to Europe only Original instructions 1155329-26 ´z+W@¶6a¨ ´z+W@¶6a¨