Husqvarna SG13A

8. Attach the yoke to the brake’s top mounting hole

using the clevis pin and cotter pin. Make sure

the rod is positioned in the bracket as shown in

Figure 4.

SET-UP

FIGURE 4

NOTE: Adjust the brake before inserting hair pin.

To engage brake, pull back on handle until brake

rod assembly goes “over center” and locks the

brake ON. Turning the yoke clockwise shortens the

rod tightening the grip on the brake disc by the brake

pads. counterclockwise loosens the clamping

force. Proper brake adjustment is such that the

wheel will not turn, but slide, when handle is over

center.

9. Remove air cleaner and double wire clamp from

engine. Figure 5.

10. Route the wire harness from engine through

guide and handle crossmember. Figure 6.

1 1. Route the throttle cable through guide on lower

handle assembly. Figure 6.

12. Connect upper and lower wire harness together.

Yellow to yellow and black to black.

13. Push throttle control lever on console forward

to full extent. Pull throttle control lever on engine

back as far as possible. See Figure 7.

FIGURE 5

FIGURE 6

1. CLAMP

2. THREAD WIRE HARNESS

AND THROTTLE CABLE

1. GUIDE

2. CLEVIS PIN (1)

1. HAIR PIN (1)