37
IMPORTANT INFORMATION
The cutters and pockets are mounted on
the cutting wheel as illustrated.
L = Left mounting
R = Right mounting
Ensure that the tooth cutters are turned
in the cutting direction.
8011-215
MAINTENANCE
Disassembling and reassembling
the blade, pockets and teeth
7. Check that the pulleys are aligned using a
staright edge along the inside face of the clutch
and pulley .
Pulleys must be inline. Maximum gap or mis-
alignment is 1/16” (.062) or 15.7 mm.
Adjust using the tension bolts as necessary.
Check belt tension again.
8. Tighten all screws and nuts when the
adjustment is complete. Be certain cover plate
is not rubbing against cutter wheel shaft.
9. Refit the belt guard.
8011-229chg
1. CHECK CLUTCH & PULLEY
ALIGN USING INSIDE F ACE
IMPORTANT INFORMATION
If pulley on cutter head shaft must be
moved, the set screws MUST be fully
removed, fresh “Loctite 242” put on
threads and re-torqued to 100 - 1 10 in./lbs.
(17513 / 19264 N•m).
1. TOOTH CUTTER
(CARBIDE F ACE)
2. CUTTING DIRECTION
1
1
2