Husqvarna SG13A

OPERATION

Using your stump grinder

WARNING!

NEVER allow the blade to touch the

ground until it has stopped turning.

1. Place the cutting blade near the top front edge

of the tree stump.

2. Set the brake to lock position.

3. Set the throttle to SLOW (START)

DISENGAGE.

4. Set engine switch on handlebar to ON.

8011-201-chg

Contents

Main Page TABLE OF CONTENTS Stump Grinder SG13A INTRODUCTION SYMBOLS AND DECALS IMPORTANT INFORMATION Decals and machine-bound instructions SYMBOLS AND DECALS Location of decals T ranslation of instructions General use Page Preparations Operating Movement/Transport Storage Children Fuel system WARNING! Maintenance WARNING! PROTECTIVE EQUIPMENT Personal equipment Equipment set-up Page Page Presentation Main components and operating controls Engine Throttle Starter Starter handle Fuel valve Choke control Air filter Spark plug Muffler Oil dipstick Oil drainage Fuel tank Cutting unit Dead man s grip bar Throttle On/Off Engine switch on the panel Brake Adjustment bar for the handle Starting the engine Page Normal shutdown Shutdown in emergency situations Page Page 6. 5. Operating on hills Transport Maintenance schedule Cleaning the cyclone filter Replacing the air filter Cleaning the sludge reservoir Idle adjustment Ignition system Adjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Adjusting the brake Two minute rule Cleaning and washing 1 . Blade shaft bearings 2 . Engine oil 3. Right wheel 4. Throttle cable TROUBLESHOOTING Page STORAGE Winter storage Service TECHNICAL DATA WIRING DIAGRAM SERVICE JOURNAL Delivery service After the first 20 hours