Maintenance and Service Instructions
When operating on hills you should consider the following:
(A)Operate the machine up and down the hills rather than across them.
(B)Use the rear wheel depth/stability control knob to set the rear wheels for extra stability. This can be a great benefit when you do choose to run the aerator across a hill. An added benefit of using the rear wheel depth control when aerating across a hill is that you will improve the consistency of the cores pulled from the uphill tines when compared to those pulled by the downhill tines.
(C)Removing the downhill weight reduces
(D)Remove remaining weight from downhill side to uphill side after each pass when operating across hills.
WARNING: NEVER DISENGAGE TINES FROM GROUND WHEN TRAVELLING UP OR DOWN HILL. ONLY DISENGAGE ON FLAT SURFACE.
TRANSPORTING THE HUSQVARNA AERATOR
MODEL AR19 and AR25
The removable weights are for side hill stability and tine penetration as applicable.
CAUTION: DO NOT LIFT AERATORS.
With the weights in place, these models are designed for easy loading and unloading on ramps and trailers. The treaded front wheel provides increased control during transport. Use engine power to load unit.
Maintenance and Service Instructions
CLEANING AND WASHING
Regular cleaning, washing and lubricating will prolong the service of your machine.
NOTE: Use care with power washers to avoid damage to Warning Decals, Operator Instruction Labels, Bearings,Chain and Engine. Limit direct spray on these items.
DO NOT EXCEED 1000 PSI WATER PRESSURE FOR CLEANING
TWO MINUTE WARNING
Aerators may be tipped on their engine guard for cleaning and access for no more than 2 minutes. Engine damage may result from gasoline draining into the crankcase if prolonged. See engine manufacturers operating and maintenance instructions.
STORAGE
1.Refer to engine manufacturers instructions for engine storage information.
2Clean machine.
3.Cover all scratches with touch up paint.
4.Lubricate according to Lubrication Schedule.
5.Lightly oil or mil board tines to inhibit rust.
6.Store unit with machine in transport position.
7.Handle may be folded.
8.Covered or indoor storage is recommended.
14