Husqvarna TS200FR owner manual Assembly, Attaching Tiller to Tractor

ASSEMBLY

When R.H., (Right Hand) or L.H. (Left Hand) are used, it means from a position behind the steering wheel as If you were seated on the tractor seat and facing forward.

NOTE: Remove mower deck from tractor before mounting tiller attachment.

•Remove tiller and bag of parts from carton.

Place tiller on level ground so that tractor can be backed up to it for assembly.

CAUTION: Tiller will be heavy when performing the following step.

Adjust tiller gauge wheels so that engine is level (Fig. 1).

•Remove retainer spring from drilled rivet.

•Remove rivet and adjust gauge wheels up or down as required to level tiller. Replace rivet and retainer spring.

ATTACHING TILLER TO TRACTOR

Optional accessory tractor weights and/or tire chains should be purchased to aid in the operation of this tiller attachment.

•Install one or more wheel weights to each rear wheel to insure good traction when operating.Tire chains can be used in place of, or in addition to, wheel weights.

•Adjust stabilizer bolts so that ends are about flush with rear of hitch bail (Fig. 2 - Inset). Leave nuts loose.

•Lower hitch assembly and slide hitch yoke of tiller (Fig. 2 - Inset) over hitch tube of sleeve hitch so that the hitch pin holes line up.

•Insert hitch pin until it extends from bottom of hitch yoke (Fig. 2 - Inset). Insert retainer spring into hitch pin.

•Tighten both stabilizer bolts against the hitch yoke until there is no looseness at the hitch point. (The frame assembly does not swing sideways relative to the hitch bail (Fig. 2). Be sure the frame assembly is perpendicular (square) to the centerline (direction of travel) of the tractor. This can be determined by mea- suring the distance between the edge of tine shield (Fig. 2) and the back of the rear tires. This distance should be the same on the R.H. and L.H. sides within 1/2 inch. Securely tighten the nuts on the stabilizer bolts.

NOTE: The stabilizer bolts should be loosened before removing the tiller from the tractor. This will make it easier to remove the hitch pin and to line up hitch pin holes when installing another attachment.If tractor is to be used without a rear attachment, the stabilizer bolt should be secured by tightening the nuts (Fig. 2-Inset).

FIG. 1

•Install two front end weights to the front of the tractor. This will aid steering control.

•	Check tractor tires for proper air pressure. See your	FIG. 2
	tractor's Owner's Manual.
•	Assemble sleeve hitch to tractor. See hitch Owner's	4
	Manual.