English-25
OPERATION
4. Adjust choke (if needed)
Do not use choke when the engine is
warm.
5. Turn ignition key to ON position.
6. Pull the recoil starter grip slowly until you
feel compression, then pull it briskly.
If the engine won´t start in three pulls,
open the choke and try again.
7. Pull the ground speed lever fully back.
8011-652
Choke control
8011-656
Ignition key
IMPORTANT INFORMATION
Do not let recoil cord snap back by itself.
This may damage the cord or the recoil
starter assembly.
8011-435
Pull the starter grip
WARNING!
Be sure all persons are clear of
area before engaging the
blades.
IMPORTANT INFORMATION
To prolong spindle bearing, clutch and belt
life, engage and disengage blades at
approximately ½ throttle.