ASSEMBLY
Fit the blade guard
WARNING! Never mount or dismount the
!blade or blade guard without first switching off the hydraulic unit and disconnecting the hydraulic hoses running to the saw unit.
Carelessness can result in serious personal injury or even death.
1Slip in the blade guard guide between the stays on the blade guard. Place the blade guard guide in the middle. Lock the plastic heel on the handle to the upper stay on the blade guard.
2Make sure that the pivot arm is positioned vertically. Lift the blade guard over the blade and hang the guard in the blade guard holder on the saw. Exercise care so that the runners on the blade guard are positioned in the slots on the water block.
3Lock the blade guard by pulling the handle out of the guard and then down towards the saw unit so that the latch locks the handle.
4To remove the guard, release the latch and pull the handle upwards and inwards to the guard. Lock the plastic heel on the upper stay.
Connect the hydraulic unit
IMPORTANT! This machine is only intended for use together with a Husqvarna PP 345 and Husqvarna RC 348. All other use is forbidden.
Please read the operator´s manual supplied with the hydraulic unit before using the machine.
When the saw unit, the blade and the blade guard are mounted, the hydraulic hoses and the water cooling should be connected.
There are two types of hydraulic hoses for the saw:
•The four thin hoses control the feed motors, i.e. the saw’s travel feed on the rail and the feed - removal of the blade. The two thick hoses drive the blade.
•The couplings should be wiped clean to reduce the risk of leakage before the hoses are fitted. Both the thin and thick hoses are locked by turning the outer sleeve on the female coupling so that the groove in the sleeve moves away from the ball.
12 – English
