Husqvarna YTH2146XP owner manual Service And Adjustments, G Mf G A E B C, TO REMOVE MOWER See Fig

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

•Depress brake pedal fully and set parking brake.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key to “STOP” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TO REMOVE MOWER (See Fig. 17)	MOWER IS TO BE MOUNTED ON THE TRACTOR,
• Place attachment clutch in “DISENGAGED” position.	REMOVE THE FRONT LINK (E) AND REAR LIFT LIKS
	(C) FROM TRACTOR AND HOOK THE CLUTCH SPRING
• Lower attachment lift lever to its lowest position.
	(Q) INTO THE CABLE GUIDE ON FRONT EDGE OF
• Roll belt off engine pulley (M) and belt keepers (G).
	LOWER DASH.
• Remove retainer spring (K), slide collar (L) off and push	TO INSTALL MOWER (See Fig. 18–21)
housing guide (P) out of bracket.
• Remove clutch cable spring (Q) from idler arm (R).	Be sure tractor is on level surface and engage parking
• Disconnect front link (E) from mower - remove retainer	brake.
spring and washer.	• Lower attachment lift lever to it's lowest position.
• Go to either side of mower and disconnect mower
suspension arm (A) from chassis pin (B) and rear lift	CAUTION: LIFT LEVER IS SPRING
link (C) from rear mower bracket (D) - remove retainer	LOADED. HAVE A TIGHT GRIP ON
springs and washers.	LIFT LEVER, LOWER IT SLOWLY AND
	ENGAGE IN LOWEST POSITION.
CAUTION: AFTER REAR LIFT LINKS
	NOTE: Be sure mower side suspension arms (A) are point-
ARE DISCONNECTED, THE ATTACH-
MENT LIFT LEVER WILL BE SPRING	ing forward before sliding mower under tractor.
LOADED. HAVE A TIGHT GRIP ON LIFT	• Slide mower under tractor until it is centered under
LEVER WHEN CHANGING POSITION	tractor.
OF THE LEVER.	• ATTACH MOWER SIDE SUSPENSION ARMS (A) TO
• Slide mower out from under right side of tractor.	CHASSIS - Position hole in arm over pin (B) on outside
	of tractor chassis and secure with retainer spring.
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE
	• Repeat on opposite side of tractor.

G MF

G

A E

B

C

D FIG. 17

18