IGSS-ESS/ESSS-0303

Electrical

WIRING COLOR CODE

GREEN

GROUND

PURPLE

ANTI-SWEAT

ORANGE

LIGHTS

YELLOW

RECEPTACLE

RED / BLACK

T-STAT /SOLENOID230V

BLACK / WHITE

T-STAT / SOLENOID 115V

BROWN

FAN MOTORS

 

 

BEFORE SERVICING

ALWAYS DISCONNECT ELECTRICAL POWER AT THE MAIN DISCONNECT WHEN SERVICING OR REPLACING ANY ELECTRICAL COMPONENT.

This includes (but not limited to) Fans, Heat-

ers, Thermostats, and Lights.

CASE MUST BE GROUNDED

NOTE: Refer to label affixed to case to determine the actual configuration as checked in the “TYPE INSTALLED” boxes.

ELECTRICAL CIRCUIT IDENTIFICATION

Standard lighting for all models will be full length fluorescent lamps located within the case at the top.

The switch controlling the lights, the plug provided for digital scale, and the thermometer are located at the rear of the case mullion.

The receptacle that is provided on the exterior back of these models is intended for computerized scales with a five amp maximum load, not for large motors or other high wattage appliances. It should be wired to a dedicated circuit.

ELECTRICAL SERVICE RECEPTACLES (When Applicable)

The receptacles located on the exterior of the merchandiser are intended for scales and lighted displays.They are not intended nor suitable for large motors or other external appliances.

FIELD WIRING & SERIAL PLATE AMPERAGE

Field Wiring must be sized for component amperes printed on the serial plate.Actual ampere draw may be less than specified. Field wiring from the refrigeration control panel to the merchandisers is required for refrigeration thermostats. Most component amperes are listed in the “Case Specs” section, but always check the serial plate.

BALLAST LOCATION

Ballasts are located within the access panel that runs the length of the rear of the case. See T-stat location for placement, as they are in the same location.1

ODY

OPTIONAL

OPTIONAL

OPTIONAL

8