hussman FMSS-L operation manual User Information Contd

IGSS-FMSS-L-0708

User Information (Cont'd)

8.Avoid the use of supplemental flood or spot lighting.

Display light intensity has been designed for maximum visibility and product life at the factory.

The use of higher output fluorescent lamps (H.O. and V.H.O.), will shorten the shelf life of the product.

Important Steps

1.Do not set temperature too cold, as this causes product dehydration. Product Temperature: 10°F!. Set thermostat to cut in at -5°F discharge air.

2.Temperature control should be by means of a T-STAT and Suction Stop Solenoid at each case. Do not use EPR valves, Liquid Line Solenoids or electronic control devices of any kind, as these allow temperature swings causing dehydration and excessive energy consumption.

Case Cleaning

Long life and satisfactory performance of any equipment are dependent upon the care given to it. To insure long life, proper sanitation and minimum maintenance costs, the refrigerator should be thoroughly cleaned frequently. SHUT OFF FAN DURING CLEANING PROCESS. It can be unplugged within the case, or shut off case at the source. The interior bottom may be cleaned with any domestic soap or detergent based cleaners. Sanitizing solutions will not harm the interior bottom, however, these solutions should always be used according to the manufacturer’s directions. It is essential to establish and regulate cleaning procedures. This will minimize bacteria causing discoloration which leads to degraded product appearance and significantly shortening product shelf life.

CAUTION

CLEANING PRECAUTIONS

When cleaning:

•Do not use high pressure water hoses

•Do not introduce water faster then waste outlet can drain

•NEVER INTRODUCE WATER ON SELF CONTAINED UNIT WITH AN EVPORATOR PAN

•NEVER USE A CLEANING OR SANITIZING SOLUTION THAT HAS AN OIL BASE (these will dissolve the butyl sealants) or an AMMONA BASE (this will corrode the copper components of the case)

•TO PRESERVE THE ATTRACTIVE FINISH:

•DO USE WATER AND A MILD DETERGENT FOR THE EXTERIOR ONLY

•DO NOT USE A CHLORANITED CLAENER ON ANY SURFACE

•DO NOT USE ABRASIVES OR STEEL WOOL SCOURING PADS (these will mar the finish)

Soap and hot water are not enough to kill this bacteria. A sanitizing solution must be included with each cleaning process to eliminate this bacteria.

1.Scrub thoroughly, cleaning all surfaces, with soap and hot water.

2.Rinse with hot water, but do not flood.

3.Apply the sanitizing solution according to Hussmann’s directions.

4.Rinse thoroughly.

5.Dry completely before resuming operation.

Cleaning Glass and Mirrors

Only use a soft cloth and water for cleaning any glass or mirrored components. Be sure to rinse and/or dry completely.

Never use hot water on cold glass surfaces! It may shatter and cause serious injury! Allow glass surfaces to warm first.

Plexiglass and Acrylic Care

Improper cleaning not only accelerates the cleaning cycle but also degrades the quality of this surface. Normal daily buffing motions can generate static cling attracting dust to the surface. Incorrect cleaning agents or cleaning cloths can cause micro scratching of the surface, causing the plastic to haze over time.

Cleaning

Hussmann recommends using a clean damp chamois, or a paper towel marketed as dust and abrasive free with 210® Plastic Cleaner and Polish available by calling Sumner Labs at 1-800-542-8656. Hard, rough cloths or paper towels will scratch the acrylic and should not be used.

Antistatic Coatings

The 210® has proven to be very effective in not only cleaning and polishing the Plexiglass surface, but also providing anti-static and anti-fog capabilities. This product also seals pores and provides a protective coating.

12