INSTALLATION and
START UP
LOCATION –
The location of y our cabinet is
important.
Make sure your selected location is
NOT
in any of the following are as as it cou
ld
seriously affect the operation.
•
Not in direct sunlight.
•
Not in the air path of heat or air
conditioning ducts.
•
Not at an exit or entrance affected by
extreme temperature change.
Allow 2 feet of clear anc e at the re ar of
the
case to allow adequate air
movement
across the condenser for
proper
refrigeration system performance, do
not
obstruct the grille at the rear intake
discharge. If desired, the bla nk off
panel
behind the front (customer side)
louvered
panel –may be removed for rear
air
intake and front air discharge, but
then
insure 2 feet of unobstructed clearance
is
left at the case front.
Level case front to back and end to
end,
shimming where necessary
upon
installation to assure proper op
erating
drains, and refrigeration system.
equipment on the same circuit. Use
a
time delay fuse or circuit breaker.
The
supply circuit mu st be properly
grounded
and conform to National and
Local
Electrical Codes. Voltage, as measured
at
the compressor terminals
during
operation, must not vary more than
5%
from cabinet serial plate rating. If a
low
voltage condition exists, contact
your
electrician or power company.
Awiring diagram is provided on the
condenser shroud for each unit.
A power (ON- OFF) switc h is provide d
on
each model. The switch is accessib
le
through ahole provided in the rear
(operator side) access panel
START UP PROCE DURE -
•
Cut the band which holds
the
compressor in place during shipment.
•
Make sure fan turns freely. Check
for
any connections or parts that
might
have loosened during shipment.
•
Start cabinet, and allow
temperature
to pull down to normal level
before
loading product.
POWER REQUIREMENTS
–
The DC models are equipped with
a
three-wire grounded service core for
your
protection. The cabinets are designed
to
operate on 115V single-phase
60hz
current. Aseparate circuit
is
recommended to prevent product loss
due
to
overloading
or
malfunction
of
other
5