P/N 0425683F | ® |
As shown in Figure 15, this can also be accomplished by pushing the magnet across the gap from the outside with a pencil or other
Use a soft cloth or paper towels, and a mild soap and water solution to thoroughly clean the gasket. Dry the gasket completely with a fresh cloth or paper towels before closing the door on a clean door frame.
Figure 15. Pulling Gasket Into Place
With a Pencil
On doors where the gap is against an end, top, or bottom mullion, this process can still be done; however, the heat will need to be directed between the lip of the mullion and the edge of the door. It will work in the same fashion but the
Cool the Gasket
Once the gap is closed, remove the heat and allow the gasket to cool, undisturbed, for 3 to 5 minutes. As the gasket cools, it will set permanently in this new shape.
Once the gasket is cool to the touch, open the and close the door. Verify that the gasket seals. If not, repeat the process. If the gasket rolls it must be replaced.
DOOR HANDLE REPLACEMENT
Carefully pull the magnetic gasket out of the groove nearest the handle to expose the mounting screws as shown in Figure 16. Remove the screws and replace the handle. After reinstalling screws, carefully push gasket back into groove. If need- ed, use a mild soap and water solution to lubricate the gasket. Clean and dry the gasket to complete the door handle replacement.
Mounting Screws
Figure 16. Replacing Door Handle
8 | HUSSMANN CORPORATION • BRIDGETON, MO |