SHIPPING DAMAGE
All equipment should be thoroughly examined for
shipping damage before and during unloading.
This equipment has been carefully inspected at
our factory. Any claim for loss or damage must be
made to the carrier. The carrier will provide any
necessary inspection reports and/or claim forms.
Apparent Loss Or Damage
If there is an obvious loss or damage, it must be
noted on the freight bill or express receipt and
signed by the carrier’s agent; otherwise, carrier
may refuse claim.
Concealed Loss Or Damage
When loss or damage is not apparent until after
equipment is uncrated, retain all packing materials
and submit a written request to the carrier for
inspection, within 15 days.
EXTERIOR LOADING
Do NOT walk on top of merchandisers or
damage to the merchandisers and serious personal
injury could occur. Merchandisers ARE NOT
STRUCTURALLY DESIGNED TO SUPPORT EXCESSIVE
EXTERNAL LOADING such as the weight of a
person. Do not place heavy objects on the case.
MERCHANDISERS SHIPPED
WITH END INSTALLED
If the case was shipped with the end installed, two
long bolts were used to hold the shipping brace to
the end. If the shipping bolts are reinserted after
removing the brace, they will extend into the
product area. Therefore, be sure to replace these
bolts with the shorter bolts provided. Refer to the
detailed information provided in the separate
End Kit Instruction shipped with each end.
Note: Be careful not to damage the factory
installed end while moving the case. Make sure
that tools are positioned past the end and beneath
the merchandiser’s support bar.
SHIPPING BRACES
Move the fixture as close as possible to its perma-
nent location and then remove all packaging and
shipping braces. Check for damage before dis-
carding packaging. Remove all separately packed
accessories such as kits, and shelves.
Remove all nut retainers used with shipping
braces.
SHIPPING RIDER
Each case is shipped on a rider to protect factory-
installed legs, and to make positioning the case
easier. Remove the rider after the case has been
positioned.
Note: Once the rider is removed, the case must
be lifted –NOT PUSHED– to reposition.
To remove the rider, remove screws attaching
each leg to rider. Remove screws holding rider
cross-members, then slide cross-members out
from between sides. Once cross-members are out,
slide the sides out.
1-2 INSTALLATIONP/N 406928
Do NOT remove shipping braces until
the merchandisers are
positioned for installation.
WARNING
!
Do not walk or put heavy objects on case.
CAUTION
!