hussman RGSSFP manual Leveling, Joint Trim, Waste Outlet and P-TRAP

Rev.0008

HUSSMANN CHINO PRODUCT CONTROL

The serial number and shipping date of all equipment has been recorded in Hussmann’s files for warranty and re- placement part purposes. All correspondence pertaining to warranty or parts ordering must include the serial num- ber of each piece of equipment involved, in order to pro- vide the customer with the correct parts.

The Hussmann warranty is printed on the back

of this guide.

Cut & Plan Views

Product temperature should always be maintained at a constant and proper temperature. This means that from the time the product is received, through storage, prepa- ration and display, the temperature of the product must be controlled to maximize life of the product.

UNCRATING THE STAND

Place the fixture as close to its permanent position as possible. Remove the top of the crate. Detach the walls from each other and remove from the skid. Unbolt the case from the skid. The fixture can now be lifted off the crate skid. Lift only at base of stand!

EXTERIOR LOADING

	Light
	Ref. Dome
	(Optional)
End
Panel	Coil
8"
12"
19 1/2"	Condensing
	Unit
	S.C.

	Elec.
"	Access
*12	"
	*5

12" 30" 8 1/4"

48"

13"

97/8"

*36"

Adj. Wire

Racks

These models have not been structurally designed to sup- port excessive external loading. Do not walk on their tops; This could cause serious personal injury and dam- age to the fixture.

AVOID REMOVING CONCRETE

All cases were leveled and joined prior to shipment to ensure closest possible fit when cases are joined in the field. To avoid removing concrete flooring, begin

lineup at highest point of store floor.

LEVELING

IMPORTANT! It is imperative that the case

				RGSSFP (S.C)
	shown with Optional Refrigerated Rear Storage
				Prep/Self-Service							In-
8"
		CONDENSING
										16"
			UNIT
			DRAIN & ELEC.			REFRIG.
						MECHANICAL
			MECHANICAL						48"
						none
			STUB UP AREA			STUB UP AREA
			18" X 18"
16"					CASE FRONT
1"	8"				8’-2" (4’-2”, 6’-2”)			1"
							8"

Plan View

LOCATION

The refrigerated merchandisers have been designed for use only in air conditioned stores where temperature and humidity are maintained at or below 75° F and 55% rela- tive humidity.DO NOT allow air conditioning, electric fans, open doors or windows (etc.) to create air currents around the merchandiser, as this will impair its correct operation.

be leveled from front to back and side to side prior to joining. A level case is necessary to insure proper operation.

JOINT TRIM

After the case has been leveled and joined, and refrigera- tion, electrical, and waste piping work completed, install the splashguards. Fasten along the top edge, or center, with #10 X 3/8" sheet metal screws.

DO NOT SEAL JOINT TRIM TO FLOOR!

Plumbing

WASTE OUTLET AND P-TRAP

The waste outlet is located off the center of the case on one side allowing drip piping to be run lengthwise under the fixture.

A 1-1/2" P-trap and threaded adapter are supplied with each fixture. The P-trap must be installed to prevent air leakage and insect entrance into the fixture.

NOTE: PVC-DWV solvent cement is recommended. Follow the manufacturer’s instructions.

3