Hustler Mini Z 36/42 & FasTrak Super Duty 36/42
Maintenance Schedule
Refer to Fig. 4-11
| WEEKLY | MONTHLY | ANNUALLY OR |
SERVICE AT | OR 50 | OR 100 | 500 |
INTERVALS INDICATED | HOURS | HOURS | HOURS |
Verify safety start interlock system |
| Daily |
|
Visually inspect unit for loose |
|
|
|
hardware and/or damaged parts |
| Daily |
|
Visually inspect tires |
| Daily |
|
Check oil level, engine (1) | Daily or every 4 hrs. | ||
Clean air intake screen (4) | Daily or every 4 hrs. | ||
Check fuel level |
| Daily |
|
Blades - sharpen & securely fastened |
| Daily |
|
Discharge chute - securely in place & |
|
|
|
in lowest position |
| Daily |
|
Clean engine and transaxle |
|
|
|
compartment |
| Daily |
|
Replace air cleaner paper element (5) |
| As needed | |
|
| ||
Change transaxle oil & filter | Every 200 hours or 2 years | ||
Grease deck height pivots | x |
|
|
Grease gauge wheel bearings | x |
|
|
Change engine oil & filter (1) (3) | x |
|
|
Clean cylinder and head fins (a) | x |
|
|
Check battery connections | x |
|
|
Check tire pressure with a gauge | x |
|
|
Check hydraulic oil level | x |
|
|
Clean engine exterior (a) | x |
|
|
Clean and regap spark plugs (a) |
| x |
|
Check pump and deck belt tension |
|
|
|
& condition (5) |
| x |
|
|
|
|
|
Check fuel and hydraulic lines (6) |
| x |
|
Check fuel valve and grommet (6) |
| x |
|
Tighten lug nuts on wheels (2) |
| x |
|
Change fuel filter |
|
| x |
Change hydraulic filter and oil (3) |
|
| x |
Replace spark plugs |
|
| x |
|
|
|
|
NOTES:
1.Initial oil change is after 5 hours of operation. Thereafter, change oil after every 40 hours operation. Change more often under dusty or dirty conditions and during hot weather periods.
2.Torque initially and after first 2 hours of operation.
3.Change engine oil filter per the engine manufacturer’s recommendations. Refer to Engine Owner’s Manual for recommendations and other maintenance items.
4.Service more often under dusty or dirty conditions. Use caution when servicing to prevent dust contamination in the engine. Do not clean filter element. Replace with a new one.
5.Pump drive belt only - Inspect every 100 hours and replace if worn or cracking is noticed. Otherwise, replace every 400 hours or 2 years whichever comes first.
6.Check fuel line hoses, fuel valve and grommets for any cracks or leaks
7.Initial system oil and filter change must be after the first 75 hours of use or 1 year whichever comes first. Thereafter, replace filter and oil in each transaxle every 2 years or 200 hours, whichever comes first.
REFERENCES:
a— Refer to Engine Owner’s Manual
NOTE: After completing maintenance cycle (500 hours), repeat cycle.
24 | 107708_0808 |
