I-Tech Company WBX-6200F-V user manual Uncompressed Initialization Codes The following runtime

FF

Flash ROM programming was successful. Next, restarting the system BIOS.

Uncompressed Initialization Codes — The following runtime

checkpoint hex codes are listed in order of execution. These codes are uncompressed in F0000h shadow RAM.

	Code		Description
03		The NMI is disabled. Next, checking for a soft reset or a power on
		condition.
05		The BIOS stack has been built. Next, disabling cache memory.
06		Uncompressing the POST code next.
07		Next, initializing the CPU and the CPU data area.
08		The CMOS checksum calculation is done next.
	0B	Next, performing any required initialization before the keyboard
		BAT command is issued.
	0C	The keyboard controller input buffer is free. Next, issuing the
		BAT command to the keyboard controller.
		The keyboard controller BAT command result has been verified.
	0E	Next, performing any necessary INIT after the K/B controller BAT
		command test.
	0F	The keyboard command byte is written next.
10		Next, issuing the pin 23 and 24 blocking and unblocking
		commands.
	Code		Description
11		Next, checking if the <End> or <Ins> keys were pressed during
		power on.
		To initialize CMOS if the initialize CMOS RAM in every boot is set
12		or the
		<End> key is pressed. Going to disable DMA and Interrupt
		controllers.
13		The video display has been disabled. Port B has been initialized.
		Next, initializing the chipset.
14		The 8254 timer test will begin next.
19		The 8254 timer test is over. Starting the memory refresh test
		next.
	1A	The memory refresh line is toggling. Checking the 15us on/off
		time next.
		Reading the 8042 input port and disabling the MEGAKEY Green
23		PC feature next. Making the BIOS code segment writable and
		performing any necessary configuration before initializing the
		interrupt vectors.
		The configuration or setup required before interrupt vector
24		initialization has completed. Interrupt vector init. is about to
		begin

37