(
RED-0º, Narrow Fan, Direct or Concentrated Cleaning.
YELLOW - 15º, Medium Fan, General Use.
WHITE - 40º, Wide Fan, Soft Pattern, For Rinsing.
BLACK - 65º, Chemical Injector Tip. Must be used when operating chemical injector
8.If using injector system, insert BLACK spray tip and connect the detergent/chemical suction line to the fitting marked “Injector” and place the filter end into the chemical/detergent jug. Turn the knob clockwise to prevent suction until desired.
9.Turn on the water supply and trigger the spray gun to purge all air from the system, PRIOR to starting engine. VERY IMPORTANT!!
10.Start the engine by following this procedure:
a.Turn the ON/OFF switch to ON.
b.Turn the GAS to ON.
c.Turn the CHOKE to FULL.
d.Push the THROTTLE lever to the ON position.
e.Pull the STARTING cord.
f.Once the engine has started, reduce the CHOKE until it is OFF, and open the THROTTLE to full ON. Use these instructions in conjunction with instructions provided in the Honda manual.
11.At this point, the gun is triggered to evacuate any remaining air in the system. Then trigger the gun and begin turning the red unloader knob in a clockwise direction as far as it will turn. You should now have full pressure.
12.To introduce chemicals/detergent to the spray, do the following;
a.Install “Black” injector tip.
b.Turn the CHEMICAL/DETERGENT adjustment knob counter- clockwise.
c.Trigger the SPRAY GUN and continue to turn the ADJUSTING knob until the desired amount of chemical flow is achieved.
d.Trigger the SPRAY GUN and continue to turn the ADJUSTING knob until the desired amount of chemical flow is achieved.
1.Trigger the spray gun and reduce the pressure by turning the unloader knob
SHUTTING DOWN THE MACHINE AFTER USE
2.Turn engine switch to the OFF position.
3.Turn the throttle and gas levers to the OFF or Closed positions.
4.Shut OFF the water.
5.Trigger gun to remove any remaining pressure in the system.
6.Disconnect hose.
H.E.R.O. Industries
Page 5 | Pressure Washer Owners Manual |
