Regularly inspect and maintain your electrical hand
tools for safe operational condition.
Do not use worn or broken tools and testers.

Never assume

that power has been disconnected
from a circuit. First,

check

that it has been
powered-off.
Always look carefully for possible hazards in your
work area. Examples of these hazards are moist
floors, nongrounded power extension cables, power
surges, and missing safety grounds.
Do not touch live electrical circuits with the reflective
surface of a plastic dental mirror. The surface is
conductive; such touching can cause personal injury
and machine damage.
Do not service the following parts

with the power on

when they are removed from their normal operating
places in a machine:
– Power supply units
– Pumps
– Blowers and fans
– Motor generators
and similar units. (This practice ensures correct
grounding of the units.)
If an electrical accident occurs:
–Use caution; do not become a victim your-
self.
– Switch off power.
– Send another person to get medical aid.
Safety Inspection Guide
The intent of this inspection guide is to assist you in identi-
fying potentially unsafe conditions on these products.
Each machine, as it was designed and built, had required
safety items installed to protect users and service per-
sonnel from injury. This guide addresses only those items.
However, good judgment should be used to identify poten-
tial safety hazards due to attachment of non-IBM features
or options not covered by this inspection guide.
If any unsafe conditions are present, you must determine
how serious the apparent hazard could be and whether
you can continue without first correcting the problem.
Consider these conditions and the safety hazards they
present:
Electrical hazards, especially primary power (primary
voltage on the frame can cause serious or fatal elec-
trical shock).
Explosive hazards, such as a damaged CRT face or
bulging capacitor
Mechanical hazards, such as loose or missing hard-
ware
Introduction 13