IBM 55P5729, 55P5776, T221, 07N2230, 13M3200, 55P5728, 07N2229 manual are squeezed together

					P/N: 55P5776
are squeezed together.					Cause 2: The monitor has downlevel firmware that does not
Or, the text on the screen is					support a converter box.
distorted and unreadable.					Action 2: Check the version of FPGA-LOGIC, as described in
					Chapter 1, Preparation for Installation. Dual-link (that is, a
					converter box) cannot be used with downlevel versions of
					FPGA-LOGIC. Use a display mode and EDID setting that does
					not require a converter box.
					Cause 3: Wrong cable connected between the converter box and
					computer.
					Action 3: Use the dedicated cable (dual- link signal cable
					(55P5729)) supplied with the converter box.
					Cause 4: Cable not attached properly.
					Action 4: Check the cable connections.
					Cause 5: The monitor's EDID setting is incorrect.
					Action 5: Set the correct value for your graphics card, referring
					to the T221 Flat-Panel Monitor Users Guide. Restart the system
					after making any changes.
Left half of the computer screen					Cause 1: Cable not attached properly.
is displayed down the center of					Action 1: Check the cable connections.
the monitor screen.
					Cause 2: You are using an unsupported graphics card, or the
					device driver is downlevel.
					Action 2: Check that the graphics card is a supported type and
					that the latest level device drivers are being used (see the T221
					Flat-Panel Monitor Users Guide for further information & details
					on how to access the web support page).
The left half and the right half of					Cause 1: Cable not attached properly.
the computer screen interchange.					Action 1: Check the cable connections.
The sizes	o f	the	left	half and	Cause 1: Cable not attached properly.
the right	half	of	the	computer	Action 1: Check the cable connections.
screen differ.
					Cause 2: The graphics card setting is incorrect.
					Action 2: Some graphics cards may require the video output
					setting changed, by using a software program associated with the
					graphics card. For details, refer to the user ’s manual for the
					graphics card.

13