Tighten screws as follows:
vPlastic to plastic
Turn an additional 90 degrees after the screw head touches the surface of the plastic part:
90 degrees more
vLogic card to plastic
Turn an additional 180 degrees after the screw head touches the surface of the logic card:
180 degrees more
vTorque driver
If you have a torque driver, refer to the “Torque” column for each step.
vMake sure you use the correct screw. If you have a torque screwdriver, tighten all screws firmly to the torque shown in the table. Never use a screw that you removed. Use a new one. Make sure the screws are tightened firmly.
2
