48 iSeries and AS/400e System Builder
#5701 #5701 PCI 1 Gbps Ethernet UTP IOA
The #5701 PCI 1 Gbps Ethernet UTP IOA allows an iSeries server to attach to IEEE standard 802.3Z high-speed (1 Gbps)
Ethernet LANs. It can also be used to connect to existing 10 Mbps or 100 Mbps Ethernet LANs by using switches with 10,
100, or 1000 Mbps ports. It cannot directly attach to 10 Mbps or 100 Mbps LANs. The adapter supports a UTP CAT 5 media
interface. Cross over cables are not supported.
The #5701 can be run under a #2792 PCI Integrated xSeries Server. If a #5701 is controlled by a #2792, then specify code
#0226 1 Gbps Ethernet Specify must be ordered. Order one #0226 for each #5701 controlled by an Integrated xSeries
Server. When not installed in an Integrated xSeries Server, there is a maximum of one #5701 per Multi-adapter Bridge
boundary. Combinations of Integrated xSeries Server controlled and PCI IOP controlled #5701s within an Multi-adapter
Bridge boundary are allowed.
PCI card slots required: One 32-bit slot in the Model SB2 or SB3 system units, or in the #0578, #5074, #0574, #5075,
#5078, #5079, #8079, #9074, #9079 PCI Expansion Towers.
For best performance, spread high-speed IOAs, such as #5701, across the system I/O buses, first by HSL loop, then by
I/O tower, and then by Multi-Adapter Bridge.
Limit the quantity of one #5701 adapter per Multi-Adapter Bridge boundary.
Can be combined with a maximum of one other IOA on an IOP.
Minimum operating system level: OS/400 V5R2 and PTF MF33086.
Does not support LAN console on OS/400 V5R2.
Supports TCP/IP only. Does not support IPX or SNA protocol.
The #5701 is a Customer Install Feature.
#6618 #6618 Integrated Netfinity Server (SPD)
The #6618 Integrated Netfinity Server contains an Intel 333 MHz Pentium II Processor, four main storage slots, and three
LAN IOA slots for high performance LAN serving to LAN-attached PCs. All three PCI slots can be used for Integrated PC
Server functions. Two of the three PCI slots can support native iSeries functions. The #6618 requires three IOP slots. The
slots must be adjacent. An external cable is included to enable connectivity to IPCS hardware (keyboard or mouse), which
also allows for optional use of parallel and serial ports.
SPD slots required: Three contiguous slots
OS/2 and Novell NetWare are not supported with OS/400 V5R1.
Supported on Models SB2 and SB3.
Minimum operating system level: OS/400 V4R3 and Cumulative PTF Package C8349430
The #6618 was withdrawn from marketing on 28 December 2001.