Auto Setup
Auto Setup
The Setup Utility included on the installation
CD is for displaying dot patterns. They do not replace or modify the display driver.
The Auto Setup instructions require the monitor to be warmed up for 15 minutes. This is not required for normal operation.
By pressing the Auto key, you will have direct access to Auto Adjustment.
Auto setup is not required when using digital input.
When you first use your monitor you must perform Auto Setup. This procedure sets up your monitor to process the video signals from your computer without image discoloration or smearing. After you perform Auto Setup, the settings are stored and used each time you turn on the monitor.
To optimise the displayed image a
ESPAÑOL DEUTSCH FRANÇAIS ENGLISH
The AUTO SETUP process only applies to the current screen mode. When a new mode is selected, repeat this section to
reset the monitor.
Operating System | Corresponding Auto Setup procedure |
DOS | Auto Setup for DOS on page 14 |
Windows 95, WIndows 98, | Auto Setup for Windows 95, Windows 98, |
Windows 2000, | |
Microsoft Windows NT®, | Windows NT, Windows 2000, Windows Me or |
Windows XP on page 15 | |
Windows Me or Windows XP |
|
Before you begin AUTO SETUP for your computer:
1.Make sure the computer’s video mode is set in the range of the supported screen resolution shown in the Table on page 23.
You should perform AUTO SETUP for each screen mode you use.
COMPL & WARR JAPANESE ITALIANO
13