
Connecting your Monitor for Analog ( for L150 and L150p)
Be sure to read the ‘Safety Information’ at the front of this User Guide before carrying out this procedure.
1.Turn off your computer and all attached devices.
2.Connect the signal cable to the video port on the back of your computer. This port might be directly attached to your computer (figure A), or it might be part of a video adapter card (figure B). The video port on your computer or video adapter card might be blue to match the blue connector on your monitor’s video cable.
3.For L150, if the power cord is not attached to the monitor, please follow
the instructions below:
a
b
a.Tilt monitor all the way forward.
b.Hold the top of the cable cover (a) and pull it off.
c.Gently lift the stand cover (b) along the top and then slide it backwards and off the stand.
d.Connect the power cord to the power port on the back of your monitor.
e.Replace the rear covers.
4.For L150p, if the power cord is not attached to the monitor, connect it to the power port on the back of the monitor.
5.Insert the plug into a properly grounded electrical outlet.
7