Auto Image Setup for DOS

ENGLISH

If the monitor is in standby mode (STANDBY ON), it

may automatically turn off while you are waiting for it to warm up. If this happens, switch off the monitor and switch it on again after a few seconds.

If you are using PC-DOS/V, change to U.S. mode by

typing ‘CHEV US’ and pressing ENTER at the command prompt.

The size and diversity of the dot pattern varies with the

screen resolution.

To optimize the displayed image automatically in DOS, do the following:

1.Turn on the monitor first; then turn on the computer.

If the message CHECK SIGNAL CABLE is displayed, or if nothing is displayed, check:

•that the video interface cable is connected properly.

•the correct video adapter card is installed.

•the correct supported display mode is selected for your computer.

2.Wait approximately 15 minutes, until the monitor warms up.

3.Insert the User’s Guide and Installation Files CD into the computer CD- ROM drive.

4.Display the command prompt screen of the DOS full-screen display.

5.Type d:\ (change the drive letter to match your CD-ROM drive if it is not drive D).

6.Type TESTPATD and press ENTER.

7.Select from the screen the number for the color or text mode you want to set up.

8.Select from the screen the number for the video mode you want to set up. You can repeat this process for as many of the color and video modes as you need.

9.When the dot pattern appears, press the OSD Enter button at the bottom of the monitor to display the initial OSD menu.

10.Use an Arrow button ( or ) to select the Image Setup icon

then press the OSD Enter button to access the function.

11.Using an Arrow button ( or ), select AUTOMATIC and press the OSD Enter button . This activates the AUTO IMAGE SETUP procedure, which will optimize the display settings with the provided dot-patterns. The screen will flash off several times and you might notice small changes to the test pattern.