Auto Image Setup for Windows 3.1, Windows 95, Windows 98, Windows NT, Windows 2000, Windows Me or Windows XP
If the monitor is in standby mode (STANDBY ON), it
may automatically turn off while you are waiting for it to warm up.
The size and diversity of the dot pattern varies with the
screen resolution.
To optimize the displayed image automatically in Windows 3.1 , Windows 95, Windows 98, Windows NT, Windows 2000, Windows Me, or Windows XP, do the following:
1.Turn on the monitor first; then the computer.
If the message CHECK SIGNAL CABLE is displayed, or if nothing is displayed, check:
•that the video interface cable is connected properly.
•the correct video adapter card is installed.
•the correct supported display mode is selected for your computer.
2.Wait approximately 15 minutes, until the monitor warms up.
3.Drag the icon bar and tool bar, if they are displayed, to the bottom of the screen.
4.Insert the User’s Guide and Installation Files CD into the computer CD- ROM drive.
5.Check the operating system installed on your computer and follow the instructions from the table below.
Position the mouse pointer 
at the bottom center of the screen. This allows AUTO IMAGE
SETUP to run properly
Operating system installation steps
Operating | Step1 | Step2 | Step3 | Step4 | |
System | |||||
|
|
|
| ||
|
|
|
|
| |
|
|
|
|
| |
Windows 3.1 | Open | Select | Select | Type | |
| PROGRAM | FILE | RUN | D:\TESTPAT | |
Windows NT 3.5 | |||||
MANAGER |
|
| (change the | ||
|
|
| |||
|
|
|
| drive letter to | |
Windows 95, |
|
|
| ||
|
|
| match your CD- | ||
Windows 98, |
|
|
| ||
Select |
|
| ROM drive if it | ||
Windows 2000, | Select RUN | ||||
is not drive D) | |||||
Windows NT, | START | ||||
|
| and press | |||
Windows Me or |
|
|
| ||
Windows XP |
|
|
| ENTER | |
|
|
|
|
| |
6.When the test pattern appears, press the OSD Enter button 
at the bottom of the monitor to display the initial OSD menu.
7.Use an Arrow button ( 
or 
) to select the Image Setup icon
and press the OSD Enter button 
to access the function.
8.Using an Arrow button ( 
or 
), select AUTOMATIC and press the OSD Enter button 
. This activates the AUTO IMAGE SETUP procedure, which will optimize the display settings with the provided test pattern.
16
