Setup
This monitor works with platforms running at horizontal frequencies between 30 and 107 kHz.
Step 1: Connect your monitor to your computer
Turn off the monitor and computer before connecting.
Notes
•Do not touch the pins of the video signal cable connector as this might bend the pins.
•When connecting the video signal cable, check the alignment of the video input connector. Do not force the video input connector in the wrong way or the pins might bend.
To a computer with an HD15 video output
Step 2:Connect the power cord
With the monitor and computer turned off, first connect the proper power cord for your local supply to the monitor, then connect it to a properly grounded power outlet.
to AC input
to a power outlet
power cord
Step 3:Turn on the monitor and computer
First turn on the monitor, then turn on the computer. | US |
The installation of your monitor is complete.
If necessary, use the monitor’s controls to adjust the picture.
If no picture appears on your screen
•Check that the monitor is correctly connected to the computer.
•If NO SIGNAL appears on the screen, confirm that your computer’s graphics board is completely seated in the correct bus slot.
•If you are replacing an old monitor with this model and OUT OF SCAN RANGE appears on the screen, reconnect the old monitor. Then adjust the computer’s graphics board so that the horizontal frequency is between 30 – 107 kHz and the vertical frequency is between 48 – 170 Hz.
For more information about the
4