2. Place the two mounting plates in the approximate mounting locations under the
rack.
3. To align the rack over the mounting plates, do the following:
a. Place the four rack-mounting bolts through the mounting holes at the bottom of
the rack.
b. Position the mounting plates under the four rack-mounting bolts so that the
mounting bolts are centered directly over the tapped holes. Insert the
rack-mounting bolts three or four rotations into the tapped holes.
4. Mark the raised-floor panel around the edge of both mounting plates.
5. Remove the mounting bolts from the threaded holes.
6. To access the holes in the mounting plates, raise the four leveling feet, and then
move the rack away from the mounting plates.
7. Mark the raised-floor panel at the center of each hole in the mounting plates
(including the tapped holes).
8. Remove the two mounting plates from the marked locations.
Chapter 1. System Installation Procedure 11