Ice-O-Matic CD300 installation manual Specifications

Specifications CD300

Specifications and Limitations

This dispenser is designed to dispense cubed ice only and to be installed and operated indoors, in a controlled enviroment. Its minimum and maximum operating temperature limits are the same as those for the ice machine.

Limitations:

￿Must meet the same limitations as the cuber installed on top of it.

￿Must allow adaquate space for air flow when using and air cooled machine.

￿Must allow space for utility connection at the back.

￿Must have a drain.

￿The CD300 is compatable with Ice-O-Matics cuber models ICE250, ICE400, ICE500 and ICE600.

￿A thermostatic bin control kit is required on all ICE Series cubers. (Part Number 1051020-02)

Operating Requirements:	Minimum	Maximum
Air Temperature	50￿ F	100￿ F
Voltage	104 VAC	126 VAC

Check the nameplate, located on the back of the dispenser cabinet for specific information.

Ice-O-Matic ice machines are not designed for outdoor installations.

Machine requires voltage indicated on rating nameplate. Failures caused by improper voltage are not considered factory defects. Extended periods of operation at temperatures exceeding limitations constitutes misuse under the terms of the Ice-O-Matic Manufacture’s Limited Warranty, resulting in a loss of warranty coverage. Specifications and design are subject to change without notice.

Ice-O-Matic assumes no liability of any kind for products manufactured by Ice-O-Matic that have been altered in any way, including the use of any parts and/or other components not specifically approved by Ice-O-Matic.

The CD300 dispenser has a 2 year Parts warranty and a 2 year Labor Warranty.

Model	Electrical	Amps	Vend Type	Finish
CD300P	115/60/1	2.2	Push Button	Stainless Steel
CD300C	115/60/1	2.2	Coin (25¢ Only)	Stainless Steel
CD300K	115/60/1	2.2	Key Card	Stainless Steel

Page 2