Initial Start Up and Use | CD300 |
Final Check List
1.Is the ice machine properly installed?
2.Is the dispenser level?
3.Has the water supply been connected to the ice machine?
4.Has the proper power been connected to the ice machine and dispenser?
Note: When electrical power is supplied to the dispenser the rotor will rotate slightly.
5. Have the drain line been connected are they separate from the ice machine?
Initial Start Up
1.Locate key and unlock the sink.
2.Remove the sink.
3.Locate the
4.Return the sink to its original position.
5.Simulate a vend. The rotor should move 1/6 (one sixth) of a revolution on push button dispensers and a full revolution on coin vending machines.
6.Record the ice machine model and serial number on the last page of this manual and on the warranty registration form. Mail the
warranty information to
Operational Note: Every 6 hours the rotor will be activated to agitate the ice. This may result in some ice in the chute.
How To Use – Push Button
The ice machine will start and run periodically to maintain the ice in the dispenser’s hopper.
Push the “ICE” button to fill the clear plastic chute with ice. Push down on the chute to release the ice into a waiting container. Allow the chute to return all the way up to its at rest position.
How To Use – Coin Vending
The ice machine will start and run periodically to maintain the ice in the dispenser’s hopper. Insert one U.S. quarter (25¢) or a special token, available from
How To Use – Room Card
The ice machine will start and run periodically to maintain the ice in the dispenser’s hopper.
Insert room card into the slot in the front of the dispenser, and push the vend button. The unit will fill the ice chute with ice, Push down on the chute to release the ice into a waiting container. Allow the chute to return all the way up to its at rest position.
Note: If the chute is not all the way up, the unit cannot resupply the chute with ice.
Page 7
