SECTION 1 SPECIFICATIONS
GENERAL• Frequency coverage | : TX: | [MARINE] | ||
| TX/RX: |
| [LMR] | |
• Number of free channels | : 22 channels |
|
| |
• Type of emission | : 16K0G3E (Wide; 25 kHz) |
| [MARINE] | |
| 16K0F3E (Wide; 25 kHz), 8K50F3E (Narrow; 12.5 kHz) | [LMR] | ||
• Antenna connector | : SMA (50 Ω) |
|
|
|
• Power supply requirement | : |
| ||
• Current drain (approx.) | : Transmit | at High (5.0 W) | 1.6 A |
|
|
| at Middle (3.0 W) | 1.2 A |
|
|
| at Low1 (1.0 W) | 0.7 A |
|
| Receive | at maximum audio | 200 mA |
|
|
| at | Less than 120 mA |
|
• Usable temperature range | : |
| [MARINE] | |
|
| [LMR] | ||
• Dimensions (projections not included) : 62(W) × 97(H) × 39(D) mm; 27⁄16(W) × 313⁄16(H) × 117⁄32(D) in. |
| |||
• Weight (with antenna, | : 280 g; 97⁄8 oz (approx.) |
|
|
• RF output power (with | : 5 W / 3 W / 1 W (High / Middle / Low) |
| |
• Modulation system | : Variable reactance frequency modulation |
| |
• Maximum frequency deviation | : ±5.0 kHz (Wide) | [MARINE] | |
| ±5.0 kHz (Wide), ±2.5 kHz (Narrow) | [LMR] | |
• Frequency error | : ±5.0 ppm |
|
|
• Spurious emissions | : |
|
|
• Adjacent channel power | : 70 dB |
| [MARINE] |
| 70 dB (Wide), 60 dB (Narrow) | [LMR] | |
• Audio harmonic distortion | : 10% at 60% deviation |
| |
• FM Hum and noise | : 40 dB |
| [MARINE] |
| 40 dB (Wide), 34 dB (Narrow) | [LMR] | |
• Limiting charact modulation | : |
| |
• Ext. microphone connector | : |
| |
RECEIVER |
|
|
|
• Receive system | : Double conversion superheterodyne system |
| |
• Intermediate frequencies | : 1st | 31.05 MHz |
|
| 2nd | 450 kHz |
|
• Sensitivity | : 0.25 µV typical at 12 dB SINAD |
| |
• Squelch sensitivity | : 0.35 µV typical at threshold |
| |
• Adjacent channel selectivity | : 70 dB typical | [MARINE] | |
| 70 dB typical (Wide), 60 dB typical (Narrow) | [LMR] | |
• Spurious response rejection | : 70 dB typical |
| |
• Intermodulation rejection ratio | : 70 dB typical |
| |
• Hum and noise | : 40 dB |
| [MARINE] |
| 40 dB (Wide), 34 dB (Narrow) | [LMR] | |
• Audio output power (at 7.2 V DC) | : 350 mW typical at 10% distortion with an 8 Ω load |
| |
• Ext. speaker connector | : |
|
Specifications are measured in accordance with
All stated specifications are subject to change without notice or obligation.
1 - 1