Icom iF25 S Conventional Operation, Turning power on, Channel selection, Call procedure

3 CONVENTIONAL OPERATION

■Turning power ON

➥Rotate [VOL] to turn power ON.

[VOL]

■Channel selection

IC-F15S/F25S:

Toggle [CHANNEL SWITCH] to select

the channel 1 or 2, or, push one of [MR- CH 1] to [MR-CH 4] key to select a chan- nel directly.

•The memory channels 3 and 4 are avail-

able when [MR-CH 3] and [MR-CH 4]

keys are assigned.

[CHANNEL SWITCH]

CONVENTIONAL OPERATION 3

■Call procedure

When your system employs tone signalling (excluding CTCSS and DTCS), the call procedure may be necessary prior to voice trans- 3 mission. The tone signalling employed may be a selective calling system which allows you to call specific station(s) only and prevent unwanted stations from contacting you.

qSelect the desired TX code channel or 2/5-tone code according

to your System Operator’s instructions.

•This may not be necessary depending on programming.

wPush the call key (assigned to one of the dealer programmable keys.) (p. 11)

eAfter transmitting a 2/5-tone code, the remainder of your com- munication can be carried out in the normal fashion.

Selective calling Non-selective calling

IC-F15/F25:

Rotate [CHANNEL SELECTOR] to se- lect the desired operating channel, in se- quence; or, push one of [MR-CH 1] to [MR-CH 4] key to select a channel di- rectly.

AUTOMATIC SCAN TYPE:

[CHANNEL

SELECTOR]

Channel setting is not necessary for this type. When turning the power ON, the transceiver automatically starts scanning. Scanning stops when receiving a call.

12 13