Controls and Indicators, IP16 Display

Up/Plus Button

Increase volume, time setting

Down/Minus Button

Decrease volume, time setting

DST On/Off button

Press to add or subtract 1 hour for daylight saving time

Controls and Indicators

Snooze/Dimmer Button

Silence alarm temporarily or adjust display brightness

Power Button

Press to power unit

ON or OFF

Alarm Button

Press and hold for

Alarm Setting mode

DC Jack

Connect AC adapter

		iP16 Display
			Alarm Indicator
			iPhone/iPod Indicator
			Sleep Indicator
			Battery Low Indicator
PM Indicator	Time Display	Daylight Saving Time
		Indicator
	Install Clock Backup Battery
The iP16 uses a CR2032 button cell battery (included with instructions) to keep
alarm and clock settings in the event of a power failure and 4 “AA” batteries to

maintain alarm operation.
If the Backup Battery has been installed and a power failure occurs or the AC
adaptor is accidentally disconnected, the display backlight will not remain lit, but
current time and alarm time settings will be temporarily maintained. Otherwise,
you must reset the time and alarm settings. If 4 “AA” batteries are installed, alarm will
operate when unit is not connected to AC adaptor.
1. Please make sure the AC adaptor is connected. Otherwise all settings may
be lost during battery replacement.
2. Open and remove the battery compartment door located on the bottom of the unit.
3. Pinch the backup battery release tab and pull the backup battery holder free.
4. Insert one CR2032 button cell battery with the + side facing upwards.
5. Replace the backup battery holder into the unit, then replace the battery
compartment door.			Pinch to release
Note: Make sure you dispose of batteries properly (see your local regulations).			Pinch to release

Note: Buttons will not function if only back up battery installed.			Installing Backup Battery
			Installing Backup Battery