TROUBLE SHOOTING
If the monitor fails to operate correctly, please follow the steps below for a possible solution.
1.Perform the adjustments described in OPERATING THE MONITOR, depending on the problem you have.
2.Consult the following charts if you cannot find an appropriate adjustment item in OPERATING THE MONITOR or if the problem persists.
3.If you are experiencing a problem which is not described below or you cannot correct the problem, discontinue using the monitor and contact your dealer or iiyama service center for further assistance.
Problem | Check |
A The picture does not appear.
(Power indicator | o The Power Cable is firmly seated in the socket. |
does not light up.) | o The Power Switch is turned ON. |
| o The AC socket is live. Please check with another piece of equipment. |
(Power indicator | See page 14 for |
is green.) | o If the blank screen saver is in active mode, touch the keyboard or the mouse. |
| o Increase the Contrast and/or Brightness. |
| o The computer is ON. |
| o The Signal Cable is properly connected. |
| o The signal timing of the computer is within the specification of the monitor. |
(Power indicator | See page 14 for |
is orange.) | o If the monitor is in power management mode, touch the keyboard or the |
| mouse. |
| o The computer is ON. |
| o The Signal Cable is properly connected. |
| o The signal timing of the computer is within the specification of the monitor. |
B The screen is not | o The Signal Cable is properly connected. |
synchronized. | o The signal timing of the computer is within the specification of the monitor. |
| o The video output level of the computer is within the specification of the |
| monitor. |
C The screen | o The signal timing of the computer is within the specification of the monitor. |
position is not in |
|
the center. |
|
ENGLISH
D The screen is too bright or too dark.
E The screen is shaking.
o The video output level of the computer is within the specification of the monitor.
The screen may be too bright due to the video output level difference of the computer. In this case, adjust the Contrast.
o Check if there are any sources of strong magnetic fields such as TV, speakers, etc. nearby.
If yes, remove them from the area of the monitor or change the position/ direction of the monitor to avoid magnetic field interference.
o The power voltage is within the specification of the monitor.
oThe signal timing of the computer is within the specification of the monitor.
o Moiré correction is working properly.
