3. Refer to the drawing on page 6 and locate the | 3 |
|
|
heater access opening. |
|
| |
Gate |
|
| |
|
|
| |
Locate the two indicated gate valves inside the | Valve | Collar |
|
|
| ||
heater access opening. Make sure that the gate |
|
| |
|
|
| |
valves are open and that the locking clips are |
|
|
|
snapped onto the stems of the gate valves (refer to |
|
|
|
the inset drawing in step 2 on page 8). |
|
|
|
Make sure that the four indicated collars are tight- |
| Collar | Gate |
ened. | Collar |
| Valve |
Refer to step 1. |
| Electronics Pack |
|
|
|
| |
(5) to the spa with the four 1/4” x 1 1/2” Machine |
|
|
|
Screws (7). |
|
|
|
4. The hydrotherapy spa operates on a 240 volt power source and must be wired directly to a 240 volt ground | |||
fault circuit interrupter (GFCI) installed in your home. This procedure must be performed by a qualified | |||
electrician. A wiring diagram is found on the inside of the electronics pack as a reference. Under no | |||
circumstances should the spa be wired by someone other than a qualified electrician. Before you | |||
have the spa wired, make sure that it is in the position you want, and that it can be easily serviced, if needed. | |||
5.After a qualified electrician has wired the spa to a 240 volt power source, refer to the inset drawing. Set the Filter (16) into the filter housing. Next, screw the Filter Cover (8) into the filter housing until it is fully seated.
Remove the two warning decals (not shown) from the spa shell. Using a damp cloth, wipe the spa shell clean. Before filling the spa, make sure that it is in the desired position and that there is room to easily service the spa. Once the spa is filled, it will have to be drained before it can be moved.
Using a garden hose or other clean water source, begin filling spa. Do not use soft water. The spa may be filled with cold water; however, if warm or hot water is used, the spa will be ready for use sooner. Fill the spa until the water is at the level shown at the right. Do not overfill the spa.
6.Pull down one of the straps on the Spa Cover (11) and hold the Buckle (30) against one of the WeatherWood™ panels on the spa. (Note: To posi- tion the Buckle correctly, have a second person hold the strap on the opposite side of the Spa Cover tight.) The Spa Cover must be tight. Do not place the Buckle over the grooves between the WeatherWood™ panels. Refer to the inset drawing. Remove the latch from the Buckle (30). Attach the Buckle to the WeatherWood™ panel with two #4 x 3/4” Screws (31).
Attach the other five Buckles (30) to the WeatherWood™ panels in the same way.
Remove the Spa Cover (11) from the spa.
5 |
| 8 |
|
| 16 |
| Fill to Here | Filter |
|
| |
Filter |
| Housing |
Housing |
|
|
6 |
|
|
11 |
| Strap |
|
| |
|
| Latch |
|
| 30 |
|
| 31 |
|
| Strap |
|
| 30 |
9
