5 Adjust the speed and incline of the treadmill.
While the walking belt is moving, adjust the
speed of the walking belt by pressing the Speed buttons. Each time one of the but-
tons is pressed, the speed will change by 0.1 mph. If the buttons are held down, the speed will change in increments of 0.5 mph. The speed range of the walking belt is 0.5 mph to 10 mph.
To vary your exercise, the incline of the
treadmill can be adjusted with the Incline buttons. Each time one of the but-
tons is pressed, the incline will change by 0.5%. The incline range is 0% to 10%. Note: After the buttons are pressed, it may take a moment for the treadmill to reach the selected incline setting.
6 Follow your progress with the five displays.
Pulse
ple your heart rate every few seconds; it may take several seconds before an accurate heart rate is shown. If your heart rate is not shown, see HEART RATE MONITOR
Calories/Fat Cal-
ories
BURNING FAT on page 28). The display will alter- nate between one number and the other every seven seconds.
Distance/Incline/
Laps display—This
display shows the dis- tance you have walked and the num- ber of
you have completed. The display will alternate be- tween one number and the other every seven sec- onds. Each time the Incline buttons are pressed, this display will show the incline setting.
Note: If the speed is displayed in miles per hour, the distance will be displayed in miles; if the speed is displayed in kilometers per hour, the dis- tance will be displayed in kilometers.
Speed/Minutes-Mile display—This display
shows the speed of the walking belt and your current pace (pace is measured in minutes
per mile). The display will alternate between one number and the other every seven seconds. Each time the Speed buttons are pressed, the display will show the speed setting.
Note: The speed can be displayed in either
miles per hour (mph) or kilometers per hour (kph). To see which unit of measurement is
selected, first hold down the Stop button while inserting the key into the console. The Speed/
Time/Segment Time display—When the
manual mode or an iFIT.com program is selected, this display
shows the elapsed
time. When a preset program or a custom program is selected, this display shows both the time re- maining in the program and the time remaining in the current period of the program. The display will alternate between one number and the other every seven seconds.
7 When you are finished exercising, stop the walking belt and remove the key.
Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest level. Next, remove the key from the console.
Keep the key in a secure place. Note: If the dis- plays and indicators on the console remain lit after the key is removed, the console is in the “demo” mode. Refer to page 22 and turn off the demo mode.
When you are finished using the treadmill, move the on/off switch near the power cord to the off position.
11
