Image IMTL94106.0 user manual Unplug the Power CORD. If the walking belt has, View

PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION: a. If the walking belt is off-center, first remove the key and	a
UNPLUG THE POWER CORD. If the walking belt has
shifted to the left, use the hex key to turn the left rear
roller bolt clockwise 1/2 of a turn; if the walking belt has
shifted to the right, turn the bolt counterclockwise 1/2 of
a turn. Be careful not to overtighten the walking belt. Then,
plug in the power cord, insert the key, and run the treadmill
for a few minutes. Repeat until the walking belt is cen-
tered.
b. If the walking belt slips when walked on, first remove the	b
key and UNPLUG THE POWER CORD. Using the hex
key, turn both rear roller bolts clockwise 1/4 of a turn.
When the walking belt is correctly tightened, you should be
able to lift each edge of the walking belt 3 to 4 inches off
the walking platform. Be careful to keep the walking belt
centered. Then, plug in the power cord, insert the key, and
walk on the treadmill for a few minutes. Repeat until the
walking belt is properly tightened.

PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key from the console and UNPLUG THE
	a
POWER CORD. Next, remove the screws from the hood
				1/8”
and carefully remove the hood. Locate the Reed Switch
							11
(17) and the Magnet (12) on the left side of the Pulley (11).					17
Turn the Pulley until the Magnet is aligned with the Reed						12
Switch. Make sure that the gap between the Magnet
and the Reed Switch is about 1/8”. If necessary, move			Top
the Reed Switch slightly using a slotted screwdriver. Re-at-		View
tach the hood and run the treadmill for a few minutes to
check for a correct speed reading.

PROBLEM: Television reception is poor

SOLUTION: a. For the television to operate properly, good reception is necessary. If you are using an antenna, make sure that it is properly connected and adjusted for optimal reception. (See HOW TO CON- NECT AN ANTENNA on page 9.)

b. Check for the problems listed below and follow the applicable instructions.

•Ignition (black spots or horizontal streaks that appear or a picture that flutters or drifts)—Usually this is caused by interference from automobile ignition systems, neon lamps, electric drifts, or other electric appliances. Try changing the position of the treadmill or other electric appliances to correct the problem.

•Ghosts—Ghosts are caused by the television signal following two paths—one is the direct path and the other is reflected from tall buildings, hills, or other objects. Change the direction or posi- tion of the antenna to improve reception.

•Blue Screen—If the treadmill is located in the fringe area of a television station where the signal is weak, the picture may be of poor quality or a blue screen may appear. If the signal is weak, it may be necessary to install an external antenna to improve the picture.

Note: If one of these symptoms appears when the cable from a CATV company is connected, the symptom may be caused by the local company broadcast.

24